JDP Roofing, registered company

Roofing Replacement Process, Roofing replacement services.

Take a clear idea of our roofing replacement process step by step.

1th step: Remove the old roofing layers it is our first step in the roof.

See the pictures below.

2th step: If need it we remove the old roof drip edge and put new one.

See the pictures below.

3th step: We repair any plywood that is in bad condition and we place new plywood where necessary.

See the pictures below.

4th step: When all the old roofing is already removed proceed to clean the roof surface.

See the pictures below.

5th step: We put special leak barrier in valley areas, roofing jack flashing, roof vents, roof turbines, chimmey flashing, skylights flashing etc, to prevent any water filtration.

See the pictures below.
Zoom Small Photo
Zoom Small Photo

6th step: Then proceed to put the new roof underlayment such as felt #15, felt #30 or synthetic underlayment.

See the pictures below.
Zoom Small Photo
Zoom Small Photo

7th step: We put special Starter strip shingles in the roof eaves.

See the pictures below.

8th step: Then we install the new roofing shingles and putting 6 nails each shingle.

See the pictures below.
Zoom Small Photo
Zoom Small Photo
Zoom Small Photo
Zoom Small Photo

9 th step: Then we painted all the roofing jack flashing, roof vents, roof turbines etc. and clean around the house all roofing trash.


Additional work to repair chimneys with the following materials of siding: Composite, Fiber cement, Vinyl and Wood. (Excludes brick , stone).

See the pictures below.
Zoom Small Photo
Zoom Small Photo
Zoom Small Photo
Zoom Small Photo